What do you need to hook up subs and an amp
Sure wish we had you guys nearby.
Cookies make wikiHow better. Run the majority of the power cable through the hole in the firewall, making sure to leave enough wire to get to the battery.
Hello, I just recently purchased a 04 Audi 2. Look for the stock amp under the center console and look for the gray 8 pin plug, pins 7 and 3; 6 and 2.
Step 1: Parts
You probably have a stock amplifier that needs to be powered up. You'll need to stay within 2—3 feet 0. Or do you prefer I try to purchase maybe a more up to date amp for my optimal set up. Hey Keith, you can grab that signal right at the stock Bose subwoofer. The remote wire needs a 12v signal to turn on the amp. That would be the proper place to wire in the remote turn on lead.
Car Audio Defined By A Chick
Mostly I did my sound system into the rear speakers not only because I did not want to spend more time in wiring it to the radio, I was unsure on the connection to do it on, because I have an older model aftermarket radio college matchmaking site is already tied into a CD changer.
How would I be able to install the most optimal setup possible? I have read that the amp also powers the door speakers. When I play the radio the sound is low, lacks bass, cannot enjoy it at all.
Warnings Always Disconnect the Negative terminal from your battery before doing anything with electricity on your car. That is feeding the actual audio signal to the amp.
Introduction: Installing Subwoofers in a Car
It already has 2 factory subs under the seats. Not Helpful 2 Helpful 5. When you look at the pictures, realize that I am using an amplifier that is too small for the subwoofer.
One way to check this is try fading just to those speakers, than balance it left and right. Connect the 3 foot, 10 gauge wire to the one marked do not connect it to the speaker negative: So you can and are supposed to have your LOC installed along side your rear speakers. All text shared under a Creative Commons License. Hi Cammy, you really should get signal from both rear speakers as your factory stereo is putting out a stereo signal to the rear speakers and the amp wants to see stereo mixed into mono.
The stock amp really is not powerful enough nor designed to run the impedance of your MTX. You have done a very good job here young man, be proud of your accomplishment. You may need to do an audio processor that sums the frequencies off the stock amp prior to your aftermarket amplifier so you can get a true full range signal. You will need a multimeter and a double AA battery with some speaker wire hooked up to it in order to test for for speaker wires and the phase.
Strip back a little bit of the wire and hook each end of the battery tester up to a pair of wires. Like if you have the Bose system?
- Gratis dating uppsala
- Dating older girlfriend
- Free dating websites chicago
- Best portuguese dating sites
- Single girl tips for dating
- Dating etiquette in brazil
- Perfspot dating
- B bar speed dating cambridge
- My daughter is dating a loser what can i do
- Dating flintshire
- Free online social dating sites
- Fast hook up canada
- Mongolian dating customs
- Dating sites parents special needs